Speed Turtle Easy Flash 2.0

Speed Turtle Easy Flash 2.0
Speed Turtle Easy Flash 2.0
Part Number: STE-EFM2-
On sale: $149.99 $139.99
Retail Price:$194.99
You Save:$55.00(28%)
1 Review(s)
Write a Review
Check out the rest, now but the best!  The Speed Turtle works while the vehicle is moving where the others don't!

The Easy Flash Module 2.0 (EFM 2.0) provides a simple and effective way to flash the factory exterior lights of supported vehicles. The system is easily installed in minutes and is a true plug and play solution.

If equipped and supported, the module will flash the following lights:
  • Front Low Beams
  • Front High Beams
  • Front Turn Signals
  • Front Fog Lamps
  • Front LED Accents
  • Rear Turn Signals
  • Rear Stop Lamps
  • Third / Center Mounted Brake Lamp
  • Reverse Lamps
  • Rear LED Accents
  • Pickup Bed Lamp
Unlike other solutions, the EFM 2.0 does not require any cutting or reconfiguration of the vehicle’s wiring harness. This allows the module to be easily installed by anyone in minutes. The plug and play installation also allows the module to be removed and installed in another vehicle without repairing or replacing vehicle components.

The system works while Parked and In Motion and uses all factory and aftermarket bulbs.  Beware of systems that only work while the vehicle is in park.

The module has two switch inputs as well as an existing vehicle button (most vehicles) that can be configured to activate the module either through a long press or quick cycle.

Choose from one of the following switch interface harnesses:
  • Toggle Switch Harness: This harness provides a simple ON/OFF toggle switch with adhesive backing. There are two internal LEDs to the toggle switch.  Green indicates the switch is ON and Red indicates the switch is in the OFF position. While this is the simplest of the two harnesses to install, it only provides one of the two possible switch inputs. The toggle switch harness is connected to Input 1 on the module.
  • Voltage Input Harness: This harness provides two ‘flying lead’ input wires. Each wire will accept a 5 – 17 volt input signal from a switch or light controller of your choice. The white wire corresponds to Input 1 and the green wire corresponds to Input 2.  This method allows you to use any aftermarket switch and allows you 2 functions such as front and rear.
Compatible with the following vehicles:
  • Chrysler 300 2011-2017
  • Chrysler Challenger 2015-2017
  • Dodge Charger 2011-2017
  • Dodge Durango 2014-2017
  • Jeep Grand Cherokee 2014-2017
  • Ram 1500 Thru 5500 2009-2017
  • Chevy Avalanche 2007-2013
  • Chevy Canyon 2015-2016
  • Chevy Colorado 2015-2016
  • Chevy Equinox 2010-2017
  • Chevy Escalade 20017-2016
  • Chevy Impala 2014-2017
  • Chevy Sierra & Silverado 1500 Thru 3500 2007-2016
  • Chevy Tahoe / Suburban / Yukon 2007-2016
  • Chevy Terrain 2010-2017

Kit includes:
  • Easy Flash Module 2.0
  • Switch interface harness of your choosing
  • 6' micro USB cable
  • Zip ties

Reward Points

280 points will be rewarded to you when you buy this item.

Browse Similar Items

Recently Viewed Items